For crack-free concrete and plaster Fibrillated Polypropylene Fibres
FibreGuard is a fibrillated polypropylene engineered fibre. Million of micro fibres (FibreGuard) get uniformly dispersed in every cubic meter of concrete and mortar as a micro reinforcement system.
Get more with FibreGuard
Reduces more than 88% of plastic shrinkage cracks and settlement cracks (test data available on request).
Reduction in permeability that prevents moisture or water from seeping. Fibrillated (Mesh) structure ensures better binding and anchoring of aggregates in concrete and mortar.
Distributes localised stresses and increases fatigue resistance. Reduces unequal bleeding that prevents uneven settling of solids in concrete and enhances cement hydration in fresh concrete, thereby increasing tensile, compressive and flexural strength. Improves fire resistance in concrete and mortars and reduces risk of spalling in concrete structures.
Increases impact strength and abrasion resistance.
Mortar
Water retaining structures
Repairs & restoration
Exposed un–reinforced concrete surfaces (CC Roads / Canal Linings)
Pre-cast concrete products
RCC concrete
Economic solutions with Fibre Guard
Helps substantially reduce the cost of waterproofing.
Helps avoid expensive creak filling sealants and fillers caused due to opening 'v’ groove and filling of surface visible cracks.
Saves cement consumption in plastering and masonry mortars.
Extends corrosion-free life of structural steel reinforcement, thereby increasing shelf life of the structure, which saves repairs and restoration cost.
Replaces expensive non-structural steel in roads and chicken mesh in buildings.
Mixer Machine
Add Fibre Guard Micro Synthetic Fibers into the mixer containing concrete and mortar aggregates. Mix it thoroughly for at least 3 to 4 minutes to ensure uniform distribution and fibrillation of fibres throughout cement, aggregates and sand mix. This mix can then be applied as per normal working conditions.
Manual Mixing
Spread Fibre Guard on the depo (heap) of dry concrete and mortar aggregates. Mix the fibres thoroughly with dry components for at least 2 to 3 minutes till the fibres are dispersed uniformly throughout cement, aggregates and sand mix. The mix can be applied as per normal working conditions.